2 AWG Welding Cable Class K 600V Cable

 Both are 600V copper welding cables; the difference is stranding. Class K uses 30 AWG strands and an EPDM jacket that resists heat, abrasion, and moisture. It’s the standard choice for welding leads, temporary power, and shop work, at a lower cost per foot. Class M uses finer 34 AWG strands and a CPE jacket, so it bends, coils, and routes more easily. Choose Class K for durability and value, and Class M when leads move constantly or run through tight spaces.

 Match the filler wire to your metal thickness and machine. As a rough guide: .023"–.024" for thin sheet and auto body work; .030" for light fabrication up to about 1/4"; .035" for general shop, trailer, and structural work from 1/8" to 1/2"; and .045" or larger for heavy plate on machines above 300A. Use solid wire with shielding gas indoors and flux-cored wire outdoors or on thick, rusty steel. Welding cable is sized separately, by your machine’s maximum amperage and the total length of the electrode and ground leads.

• Size the cable to your welder’s max output and total lead length; undersized leads overheat.
• Turn off the welder before connecting or swapping leads.
• Inspect jackets every shift and replace damaged sections instead of taping them.
• Keep lugs and connectors tight; loose ones overheat.
• Clamp the ground on clean metal close to the weld.
• Fully uncoil leads before welding.
• Keep leads out of water and away from sharp edges, hot slag, and traffic.
• Never wrap leads around your body.

 Customers use 2 AWG welding cable for winch power and ground leads, car audio amplifier wiring, truck and marine battery cables, and inverter connections in mid-size solar and RV systems. Its flexibility also suits forklift and equipment battery leads. Check local code before using welding cable for permanent building wiring.