Product Information

Specification

About:

This tray cable features an Okoguard insulation, which is Okonite’s proprietary ethylene-propylene rubber insulation. It has excellent electrical properties, including high dielectric strength and physical toughness. The bare copper conductor is unshielded, making it more flexible and easier to install in certain environments. The Okoclear-TS is a thermoset compound that enhances the cable's performance in terms of heat, moisture, and chemical resistance.

Also Known As:

• Okoguard Tray Cable
• Bare Copper Tray Cable

Application:

• Okoguard-Okoclear-TS 1000V and 2000V Power and Control Cables are recommended for use in all low voltage circuits where continuity of service is the prime consideration. Ideal for applications where smoke or halogen off gases are a concern in the event of a fire.
• These cables may be installed in wet or dry locations, indoors or outdoors, in raceways, underground ducts, or lashed to a messenger for aerial installation. 
• These cables may also be installed in cable tray (size 1/0 AWG and larger per NEC 392.10(B)(1)).

Standards:

• CSA RW90: This indicates the cable meets Canadian Standards Association requirements for 90°C wet and dry locations.
• RHW-2: Suitable for both wet or dry locations at temperatures up to 90°C; can be used in a variety of environmental conditions.
• UL Listed: Recognized by the Underwriters Laboratories for safety standards.
• IEEE 1202 (FT4 Rating): Meets the flame test requirements for a Flame Retardant Category 4.

Construction:

• Conductor: Uncoated soft copper per ASTM B-3. Sizes larger than 1000 kcmil are compressed stranded per ASTM B-8. Sizes 1000 kcmil and smaller are compact stranded per ASTM B-496.
• Insulation: Meets or exceeds all requirements of ICEA S-95-658, NEMA WC70 and UL 44. 
• Listed by Underwriters Laboratories, Inc. as Type RHH or RHW-2 and sunlight resistant. Sizes 1/0 AWG and larger are marked for use in cable tray.
• Listed by CSA as RW90, -40°C, FT1, SR, Hal Free, PRI, PRII, GRI, GRII, TC, TC-ER, and FT4-ST1. 600V constructions are also available

Features:

• Low smoke zero halogen design.
• Sizes 1/0 AWG and larger pass the Vertical Tray Flame Test with limited smoke requirements of UL 1685 for use in cable tray.
• UL Sizes 1/0 & larger are marked ST1.
• Passes the IEEE 383-1974 Vertical Tray Flame Test.
• Sizes 500 kcmil & larger pass the Vertical Tray Flame Test with limited smoke requirement of UL1685-IEEE 1202 exposure.
• Oil Resistant I & II.
• Extreme heat resistance: 90°C continuous rating, wet or dry
                                          130°C emergency overload rating
                                          250°C short circuit rating
• Exceptional resistance to deformation at high temperature.
• Stable electrical properties.
• Low SIC and power factor.
• Low moisture absorption.
• Mechanically rugged.
• Resistant to weather, most oils, acids and alkalies.
• Most flexible, easier to install and terminate than XLPE insulation.

*Data provided on this page is subject to change based on different manufacturers' variances

** Images are for display purposes only refer to Product Technical Details for accurate information on the product.