1/4" Male SAE 45 Degree Flared x 1/4" MNPTF Ball Check Connector 10256WC

Product Information

Specification

1/4" x 1/4" M Flare X MIP Ball Check Connector 10256WC

Description:

1/4 x 1/4 M FLARE X MIP BALL CHECK CONNECTOR  

Features:

Typical Application:

◑ LP and natural gas, flammable liquids, instrumentation, refrigeration, power steering, hydraulic and pneumatic systems.

Working Pressure Ranges

◑ Temperature and type of tubing used are important factors. However, the following table is a good guide for proper selection. Temperature 730 F with copper tubing:

Tolerance:

◑ +/- .03 on all dimensions. Dimension data can change without notice. Please call us when dimensions are critical.

Conformance:

◑ Meets specifications and standards of ASA, ASME, SAE, and MS (Military standards).

Assembly Instructions:

1- Cut the tubing to the desired length. Make sure all burrs are removed and ends are cut square.

2- Slide the nut on the tube. Threaded end “A” of nut must face out.

3- Flare the end of the tube with a 450 flaring tool. a-Measure flare diameter. b- Examine flare for excessive thinning out.

4- Lubricate threads and assemble to fitting body. The nut should be turned hand-tight.

5- Tighten the assembly with a wrench until a solid feeling is encountered. From that point, apply a one-sixth turn.

Vibration Good resistance:

◑ use long nuts when greater vibration resistance is required. 

Temperature Range:

◑ -650 F to +2500 F (-530 C to +1210 C) range at maximum operating pressures.

Used:

◑ With Copper, brass, aluminum, and steel hydraulic tubing that can be flared.

  View Catalog Page