Product Information

Specification

NMEA 2000 Micro-Change M12 Terminator Resistor PCM-N2C-01

Description:

The Terminator, a M12 connector molded with a 120 ohm resistor inside it, located at each end of the NMEA 2000 backbone or other devices cable termination. Proper termination helps ensure signal integrity across the entire length of the boat backbone.

Male CAN terminator, provides CAN bus termination for proper working.

Certified NMEA2000 - Terminators.  NMEA 2000 networks need terminating resistors at either end to terminate or close the NMEA 2000 network and should be installed on one side of a T-connector.

NMEA 2000 M12 Waterproof Connector Termination Resistor For Marine Vessel.

NMEA2000 Connector Termination Resistor is used to terminate a NMEA 2000 network.

High quality NMEA-2000 compatible cables and connectors that are perfect for marine electronics communications. 

Two termination resistors are required on every NMEA 2000 network, one on each end of the trunk line. Normally, a male termination is used since male pins tend to point back to the power source. 

Compatible with NMEA-2000 enabled chart plotters, fish finders and sounders. The range covers backbone cables, tee's, resistive terminators,elbow connectors, multi-junction connectors and starter kits.

Termination Resistor NMEA 2000 Micro-C

NMEA2000 Backbone terminator

NMEA2000 Inline-Terminator.