Product Information

Specification

18 AWG 4P TC FR-EPR Shielded Pairs Overall Shield Instrumentation Cable 600V

Application:

• UL listed and OSHA acceptable. Recognized for use in Class 1 or 2, Division 2 hazardous locations. Suitable for use in cable trays, raceways, ducts and conduits, direct burial or supported by a messenger for use at temperature ratings not exceeding 90°C in wet or dry locations and outdoors where a sunlight resistant rating is required. These cables shall conform to (UL) Type TC Power and Control Tray Cables and National Electrical Code Articles 336, 392, 500 and 501. These cables pass the IEEE-383 70,000 BTU flame test, the IEEE 1202 flame test and the ICEA T-29-520 210,000 BTU flame test. Designed for control, power, lighting, telemetry, signals and relay or traffic control.

Scope:

• This specification covers the minimum construction requirements for paired cables (UL) listed Type TC consisting of Class B stranded annealed tinned copper, insulated with cross-linked polyethylene, cabled together and jacketed overallwith a chlorinated polyethylene (CPE) jacket.

Also Known As:

18 AWG 4P Instrumentation Cable, Tray Cable, 18 AWG 4P FR-EPR Shielded Instrumentation Cable, 18 AWG 4P 600V Shield Instrumentation Cable, FR-EPR Shielded Cable.

Construction:

Conductors: 

Class B (7 wires) annealed tinned copper.

Insulation:

Flame retardant EPR shall be applied concentrically over each conductor and shall conform to (UL).

Drain Wire:

Class B (7 wires) annealed tinned copper.

Overall Jacket:

A black, flame, moisture, oil and sunlight resistant chlorinated polyethylene (CPE) jacket meeting the requirements of UL-1277 shall be applied concentrically overall. The physical properties of the jacket comply with Table 50.28 of UL-1581. A high strength nylon yarn rip cord shall be placed under the jacket to facilitate stripping of the jacket.

Shielding: 

Each pair has an individual shield consisting of a 1.35 mil thickness aluminum/ polyester tape with a drain wire, plus a 1.35 mil thickness aluminum/polyester tape shield and drain wire overall (100% coverage).

Specifications:

• AWG: 18
• No. of Pairs: 4
• Nominal Jacket Thickness (In): .060 
• Nominal Outside Diameter (In): .62
• Minimum Bend Radius (In): 7.5 
• Maximum Pull Tension (Pounds): 136
• Approx. Weight 1000 FT (Pounds): 183 

*Data provided on this page is subject to change based on different manufacturers' variances

** Images are for display purposes only refer to Product Technical Details for accurate information on the product.

In the case the material only comes in a predetermined color or doesn’t come with any color