902 MHz Wall Switch Receiver WSS20-N9N

Product Information

Specification

About:

• Using EnOcean technology, but upgraded to the proven 902MHz radio frequency, the WSS20 leads the industry in quality and reliability.
• The WSS20 is compatible with all Leviton 902MHz EnOcean-enabled self-powered transmitters.
• The WSS20 is the optimal solution for retrofit applications where incandescent, fluorescent and low-voltage lighting controls are required.
• The WSS20 replaces a traditional single-pole wall switch and fits in a standard single-gang wall box. No additional wiring is required.

Also known as:

Decora Switch, Decora Rocker Wall Switch, Electrical Switches, Switch button, Switch controller, Switch circuit breaker, light Switches, ON/OFF Switch, Tumbler switches, Wall Switch Receiver.

Specification:

Product Type: Wall Switch Receiver
Protocol: 902 MHz EnOcean
Product Line: LevNet RF
UPC Code: 078477671788

Feauters:

• No New Wiring Required — the LevNet RF Wall Switch Receivers simply replaces the existing light switch and communicates with self-powered switches and sensors via radio 902MHz frequency
• Vacancy Switching — provides pushbutton manual-ON/OFF light switching of each light load at any time
•Walk-Thru Feature — maximizes energy savings by assuring a 2.5 minute time-out if motion is not present after 2.5 minutes in Auto-ON mode
• Standard Size for Seamless Installation — LevNet RF Wall Switch Receivers fit in a standard single gang wall box
• Required Wiring - neutral and non-neutral models available; non-neutral requires 25W minimum load
• Zero-Cross Relay: switches at the zero crossing point of the AC power curve to ensure maximum contractor life and compatibility with electronic ballasts
• Energy Savings and Efficiency — lowest power consumption of any RF device - less than 1/2W per 120V device and less than 2/3W per 277V device annually - approximately 70% savings over other RF devices
• 10A load rating — for commercial lighting circuits